Difference between revisions of "InitLabv3/Printers/HP LaserJet 3030"

From initLab
Jump to navigation Jump to search
(Created page with "= TL;DR = '''Model:''' HP LaserJet 3030 '''URI:''' ''socket://172.31.190.43:9100'' '''Location:''' lecture room '''Type:''' black & white printer with ADF scanner (the sca...")
 
Line 37: Line 37:


TODO: connect to the initlab telephony network
TODO: connect to the initlab telephony network
== Implementation Notes ==
The print server is hosted on [https://wikidevi.com/wiki/Linksys_NSLU2 Linksys NSLU2] running OpenWRT 18.06 and p910nd. The device was generously provided by ignisf.
The device is connected using wired connection to the initlab network and uses usb2parallel cable for communicating to the printer, so that the usb connection is available for scanning. For some reason in order for the printer to be seen an usb hub is required.
A hardware hack has been applied so that the device boots on power-on (the power must be out for at least 5-10 sec).
The majority of initlab power users have access ssh access to the device (including maniax, lz1irq, ignisf, Slackware).

Revision as of 00:11, 21 January 2019

TL;DR

Model: HP LaserJet 3030

URI: socket://172.31.190.43:9100

Location: lecture room

Type: black & white printer with ADF scanner (the scanner is over usb)

Overview

One of the printers in InitLab is multifunctional laserjet HP LaserJet 3030.

It can be accessed for printing on URI: socket://172.31.190.43:9100

For scanning there is an attached location

Network Printing Instructions

See how to connect over ticket

On windows one can use HP LaserJet 3050 driver.

Scanner

There is an USB cable attached to the printer for scanning.

For linux - use the hplip packages sudo apt install hplip && hp-setup

For scanning: hp-scan --adf --output=scan.pdf --size=A4 --mode=color and select the printer.

The flatbed does not seem to work on linux.

Fax

TODO: connect to the initlab telephony network

Implementation Notes

The print server is hosted on Linksys NSLU2 running OpenWRT 18.06 and p910nd. The device was generously provided by ignisf.

The device is connected using wired connection to the initlab network and uses usb2parallel cable for communicating to the printer, so that the usb connection is available for scanning. For some reason in order for the printer to be seen an usb hub is required.

A hardware hack has been applied so that the device boots on power-on (the power must be out for at least 5-10 sec).

The majority of initlab power users have access ssh access to the device (including maniax, lz1irq, ignisf, Slackware).